help kids are 2 days that I fight with a matiz control unit kemsco d3 does not start error in the ecu 2 "incorrect calculation and immobilizatore"
I've done everything in my possession, but still not changed the box code put new chip keys, nothing the same error
tried to do a partial on the 29f200
while the others are still talking about us, we have already solved the problem
GARAGE0864 ԼЄƓЄƝƊƛƦƳƧԼƛVЄ
If not remember bad for those of us wants the e xxx. Go with that and you take out any problem
I confirm the total, nothing,you can do only partial,we want to emulator!!
You do not really understand something until you can explain it to your grandmother (Einstein)
already tried scodifica partial 2 times
I also put in the emulator, the same thing is not part ilprobleema and even after you've changed the box code and made new keys put the ecu virgin I still have the same error "no response to the release" on the ecu and immo on the engine control unit, which now marks the ecu virgin I have a error immobilizatore and incorrect calculation I would not like it's really the ecu that wentOriginally Written by motorsport
Last edited by msport (exil77grande); 01-06-2013 at 17:40
OK have you done the new keys,but you have done the fit with the diagnosis??? if you have the Texa do it without problems!!!
You do not really understand something until you can explain it to your grandmother (Einstein)
A stupid question.... After the installation of the emulator code, you have detached the immobilizer?
Emulator for daewo autocode and cut immo pin on the ecu, made dozens and-games-to-first shot
Another thing, if you unplugged the flash make sure that there are no residues of the resin, otherwise the welds could create some problems
sure, I have put the emulator as shown in the diagram inside the ecu cut the pin 56 (which if I'm not mistaken, and also the thread of the k-line diagnosis) equal to is not part
you flash the detached 2 times, checked the pins one by one the welds are perfect 1 question, but with the emulator seve put it virgin or don't need ? Tuesday I get a new ecu I have to scodificare to put the emulator or also coded ?
I have done 20 times the adaptation of the texa is the whole procedure but the same thing does not start a thing that I have noticed that after adaptation with the texa and obviously not the part I re-read the file inside the box code and is not changed anything that I had written it myself so I think that the procedure is not working
Last edited by msport (exil77grande); 03-06-2013 at 08:41
I'm becoming crazy, I put another ecu (I don't know if that also fails, too ) the same problem immo active, and not even with the emulator who gives me some solution aiutooooooooo
I confirmed that with the emulator should start the controller and a kemsko d3 cut the wire 56 immo mounted emulator siaccende the green led flashes 3 times red led (on the emulator) will turn off but the bastard is not part
Write permission
Quote